• Overview

• By Category

• By Product
• Dielectric Fault Analyzer DFA100
• Doble Test Assistant Software
• DOMINO Sensor
• F Protection Series
• Insulator Pollution Monitor
• Intelligent Diagnostic Devices
• Leakage Current Monitor
• M2H - MCM
• M4000 Series
  • Features
  • Software
  • Product Options
• M5000 Series
• Partial Discharge Detection
• ProTesT software
• TDR Series

M4000 Software

Provides advanced control of the M4100 for creating, running, and saving tests

M4000 software, run on a user-supplied laptop or M4200c Controller, allows you to perform tests using four modes:

Clipboard Mode

Clipboard mode is a generic form for recording and storing test results, nameplate information, weather conditions, test parameters, and notes. A graphing function allows you to graph test results.

External Reference/Source Mode

External Reference/Source mode allows you to perform tests using an external reference and voltage source, extending the range of test voltage above the 12 kV of the M4100 test set.

Leakage Reactance Mode

Leakage Reactance mode allows you to measure transformer leakage reactance. Auxiliary hardware is required in the form of the M4110 Leakage Reactance Interface or the M4130 Leakage Reactance Module.

DTA Mode

DTA mode opens DTA Field software if it is installed on your machine.